Barely used Komatsu PC400/PC450 Excavator Dipper Arm Stick, Bucket Ram & Linkages

DESCRIPTION

Barely used Komatsu PC400 / PC450 Excavator Dipper Arm Stick including bucket Ram & Linkages.

Condition is used but other than some paint chips, it is in perfect condition, no cracks or wear etc. The Ram chrome looks perfect.

* Front Pin hole (hole at very left in pic# 1): 115mm diameter, width: 354mm but there are flanges inserted in the hole that make the overall width 378mm (see bottom of pic# 3 to see flanges that poke out past the hole).
* Linkage Pin hole (hole in H-linkage, just above Front Pin hole in pic# 1): 100mm diameter, width: 369mm.

* Connect Arm to Boom pin hole (hole near right edge of pallet in pic# 1): 120mm diameter, 350mm deep.

* Arm to Boom Ram pin hole (hole at very right in pic# 1): 110mm diameter.

* Pin center of Front Pin hole (hole at very left in pic# 1) to Pin center of Connect Arm to Boom pin hole (hole near right edge of pallet in pic# 1): 2397mm (give or take a few mm), this is know as the "Working Length".

* Cylinder Diameter: approx 200mm (approx 255mm at 12 bolt flange).
* Ram (chrome) Diameter: approx 120mm.

Should Fit: Komatsu PC400 / PC400LC / PC450 / PC450 LC.

Overall Shipping Dimensions (laying on its side as in pic# 9):
3755mm Long, 1220mm Wide, 565mm High (at the linkage pin). Weight: 2,256kg.

Call if you would like to discuss or to come inspect it.

We are at
You can pick up, we can deliver to a reasonable distance for an agreed fee, or we can arrange freight within Australia.

(MIC_1152AR2304190518A)